585,729 active members*
4,480 visitors online*
Register for free
Login
IndustryArena Forum > CNC Plasma, EDM / Waterjet Machines > CNC Plasma / Oxy Fuel Cutting Machines > Best way to get a 100:1 arc voltage out of Powermax 85

Thread: Best way to get a 100:1 arc voltage out of Powermax 85

Results 1 to 2 of 2
  1. 09-17-2021, 01:00 PM #1
    SSOKIE
    SSOKIE is offline
    Join Date
    May 2016
    Posts
    2

    Best way to get a 100:1 arc voltage out of Powermax 85

    I'm surprised I can't find anywhere this has been mentioned before here, but I have searched up and down and can't find it, so...

    What's the simplest and/or best way to get a 100:1 signal from a Powermax 85 divider board?

    I realize a 100:1 signal is not the best to use but I'd still like to know.

    Thanks
    Reply With Quote Reply With Quote
  2. 09-18-2021, 07:24 AM #2
    joeavaerage
    joeavaerage is offline Member
    Join Date
    Nov 2013
    Posts
    4361

    Re: Best way to get a 100:1 arc voltage out of Powermax 85

    Hi,
    Hypertherm machines typically have a 50:1 divider. If you really must have a 100:1 then just add a 2:1 divider at the output of the 50:1.

    Craig
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Raw Arc Voltage Points on Powermax 1100
    By Donn in forum Hypertherm Plasma
    Replies: 12
    Last Post: 01-17-2016, 08:22 PM
  2. Powermax 85 torch loses arc
    By esp173 in forum Hypertherm Plasma
    Replies: 3
    Last Post: 09-24-2015, 07:22 AM
  3. Powermax 45 intermittent arc loss
    By drumsticksplint in forum Hypertherm Plasma
    Replies: 4
    Last Post: 04-19-2014, 10:55 PM
  4. Powermax 45, arc stops after pierce intermittently
    By DirtBound in forum Hypertherm Plasma
    Replies: 3
    Last Post: 01-24-2014, 07:38 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules