Hi all

Im getting ready to put together a new PlanetCNC Mk3/4 board based X2 mill controller, using the PlanetCNC software.

While I will be using a connected laptop all the time I am using it for machining, I would like to be able to output the X,Y and Z positions to a separate display so that I can use it for 'manual' work.

Is there a way to do this, either via the board direct or via some kind of USB output. Ideally, both absolute and relative dimensions would be displayed. I would probably try to install remote zeroing and jog buttons, but believe that is all within the board capability already.

Cheers

Les