Good morning,
I would like to know which M-code should I use after collet open to delay the headstock movements in order for the synchro device of the bar feeder to engage properly.
Lathe: Citizen L 32 VIII
Bar Feeder: IEMCA Boss 338
Thank you,
Good morning,
I would like to know which M-code should I use after collet open to delay the headstock movements in order for the synchro device of the bar feeder to engage properly.
Lathe: Citizen L 32 VIII
Bar Feeder: IEMCA Boss 338
Thank you,
Maybe a G4 Pnnnn ?
Jim Dawson
Sandy, Oregon, USA