Using Mach3 software,
Just installed a new ethernet controller, AXBB-E From CNC Drive, Was using a USB interface controller,
Whole new ballgame, I got the Unit working FINALLY,, And Now the Motors X Y and Z all running and in proper directions,
Trying to calibrate motor movement now,
I pull up settings and go to the Axis Calibrate,,
The window pops up,, But will NOT ACCEPT any input at all,, On any axis, I checked to be sure my Numbers Lock was on, And working, Rebooted system,
Nothing seems to help,
I am thinking that there is something Not configured right,
But after searching everywhere, I'm lost as a ball in High Weeds,,
Any help is much appreciated,
Cubs,,