I know this has been covered before but was only answered regarding fusion 360. Is there a way to put toolpaths together from multiple work offsets to avoid tool changes. Copy and paste editing is too cumbersome and too easy to create errors.
I know this has been covered before but was only answered regarding fusion 360. Is there a way to put toolpaths together from multiple work offsets to avoid tool changes. Copy and paste editing is too cumbersome and too easy to create errors.
I know you can have multiple 'setups'.
So setup #1 can be toolpath in one 0 position.
Then setup #2 can be another tool path from a different 0 position.
Then setup #3, setup #4 etc. Can't remember if it puts them all together in one post or not.
You can deselect 'tool change' in the tool pages.
Yes it does indeed work as dazp1976 says. I use Inventor CAM and you can many setups with different zero positions and it will post as one continuous file it only stops if there is a different tool otherwise it just runs beautifully.