Picking am picking up a Tormach 1100 that is on the deluxe stand.

I think I will need to pull the chip pan off to facilitate strapping it down. I won't have too much time to prep, so I am wondering what I need to remove it?

https://tormach.com/media/asset/t/d/...16a_web_1_.pdf

Install manual says M6x10mm. Are these socket head cap screws? Should be a 5mm driver.

There are also a few M6x10mm screws with nuts.

I'll have a utility knife to cut any sealant. Anything else I will need?