548,322 active members*
2,689 visitors online*
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > EdingCNC > software stuck in sim mode/deactivate pause
Results 1 to 2 of 2
  1. #1

    software stuck in sim mode/deactivate pause

    hi, old mentor builds surfboards, uses eding software to control machine. says the software is defaulting to simulation mode, even when following proper startup protocol. when manually getting out of simulation mode, he is getting an alert telling him to "deactivate pause." (see attached photos) any ideas? thanks

  2. #2

    Join Date
    Apr 2021
    Posts
    1

    Re: software stuck in sim mode/deactivate pause

    Hello,
    What is your hardware card model?
    Is it the first use?

Similar Threads

  1. Need Help. Stuck in MDI mode.
    By 308billw in forum Hyundai Kia
    Replies: 0
    Last Post: 09-10-2019, 08:03 PM
  2. UCCNC Software Stuck in Demo Mode
    By Andrew22 in forum UCCNC Control Software
    Replies: 3
    Last Post: 12-23-2016, 06:38 PM
  3. Replies: 0
    Last Post: 10-05-2015, 11:10 AM
  4. Replies: 2
    Last Post: 11-14-2013, 12:21 PM
  5. GibbsCam trying Machine Sim Mode
    By 303cutter in forum GibbsCAM
    Replies: 1
    Last Post: 07-11-2008, 02:34 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •