[mazpuruav]

Good morning,

I would like to know which M-code should I use after collet open to delay the headstock movements in order for the synchro device of the bar feeder to engage properly.

Lathe: Citizen L 32 VIII

Bar Feeder: IEMCA Boss 338

Thank you,

[Jim Dawson]

Maybe a G4 Pnnnn ?

[cogsman1]

Good morning,

I would like to know which M-code should I use after collet open to delay the headstock movements in order for the synchro device of the bar feeder to engage properly.

Lathe: Citizen L 32 VIII

Bar Feeder: IEMCA Boss 338

Thank you,

Using the G4U## delay between open and moving could work but you could also fixe the barfeeder parameter to allow more time.
Iemca parameters #9 & #10 are delays for "Open collet thrust delay", "Close collet thrust delay".