[arash1998]

Hi all
I have a doosan VM960L with a Fanuc control 31i
when i put in jog type and press the keys (for example X+ ) all the value (abs. relative machine) work normally. For example when press positive key value goes up and press negative keys values goes down but any of the axis didn`t move.
When i see the cabinet i understand that all of my drives are in "not ready" state
i have not any erors o alarms in messages tab.
what should i do !?
Thanks all

[oetkbyentc]

Please clarify some details.

-In the current state when you jog an axis the position display updates but the axis do not mechanically move. And if you move a large amount you do not get excess error alarms.
If the above is true.
-On the FSSB screen under System is there any indication of trouble? Are all drives / axis displayed normally.
-On the status bar of the display you do not see a "--EMG--" or "-RESET-"
-You have "-" on the axis (not spindle) drives vs "0" which indicates not ready
-Has anyone had cause to change parameters?
-Is there per chance a MLK or Machine Lock switch on the operators panel that has been turned on?
-There are no indictors next to the axis names on the position display screed "D", "I", "S".