Re: milling supper thin material.
Originally Posted by
longnho
I told them about that but they still asked me use material they supplied. so face it to the thickness of the part is only one choice
I would not do the job, that is the craziest thing I ever heard.
If you insist on doing the job, then glue the material to something flat and reasonably stiff that you can hold in your vice or clamp to your table. Then do the machine work, and then hand them the whole work piece and they can figure out how the release the glue without destroying the part. Oh and charge them a lot to do the work.
Jim Dawson
Sandy, Oregon, USA