Anyone ever have any unplanned movements on a Centurion 6 control that are NOT obvious in the gcode?
I had a crash today when a large circle (12" or so) appeared in the middle of a program. It was not commanded in the Gcode and did not show up in Fusion360s simulation or NCviewers simulation of the posted code from fusion.
Unplanned move happened during a G3 IJ arc move ( 3D contour tool path).
This move DID show up in the Centurions controls verify feature (checked after the fact).
I suppose I need to run that on every program for now......verify is so SLOWWW on these longer toolpaths.
Also the mirrored version of this toolpath on the flip side of part did not have this anomaly show up.
Next step is going back over the changes I made to see what might have caused it - the only thing I recall that could have had effect on that part of the program was messing with Fusions smoothing settings.
Any thoughts?
PS. I am new so go easy on me.
Eric