Hi,
So the increment buttons on the controls for rates are 25%, I want them to be 2% for my application. It is very useful to make 2% changes to cancel harmonics, and even make minor feedrate changes... 25% is way too much most of the time.
I can't find a way to change this, any ideas?
Results 1 to 2 of 2
Hybrid View
-
11-01-2021, 05:41 PM #1
Member
- Join Date
- Apr 2020
- Posts
- 15
Changing the feedrate / spindle increment buttons percentage
-
11-07-2021, 11:08 PM #2
Registered
- Join Date
- May 2010
- Posts
- 13
Re: Changing the feedrate / spindle increment buttons percentage
In the Mach3 Config \ General Logic Configuration, on the far right side there is a 'Spindle OV increment' setting which can be changed.
Not sure about the feed rate, but mine seems to go at 10% steps.
Just found and old MachSupport post
https://www.machsupport.com/forum/in...?topic=12503.0
that has some suggestions... I haven't tried them.
Reply With QuoteSimilar Threads
-
macnine settings v25 for gap percentage
By alan collins in forum Australia, New Zealand Club HouseReplies: 0Last Post: 03-16-2014, 12:26 PM -
Kress spindle - maximum feedrate
By Busch_dk in forum DIY CNC Router Table MachinesReplies: 2Last Post: 03-10-2014, 05:47 AM -
Shrinkage percentage
By zeeshan.insight in forum MoldmakingReplies: 7Last Post: 06-21-2008, 02:56 PM -
Changing Fanuc part counter increment?
By gearsoup in forum FanucReplies: 4Last Post: 06-23-2007, 01:50 PM -
Spindle speeds and feedrate cap
By HuFlungDung in forum OneCNCReplies: 11Last Post: 07-05-2005, 06:05 PM
Tags for this Thread
Posting Permissions
