[Christiaan]

Goodmorning,

I own a Biesse Rover 13 point to point router and after having problems with the electricity in my shop which are now, after one year (!) solved, I can start the working cycle till the moment where the front and side stops should go out. There is no green light on the two start push-buttons, also there will be no vacuum on the table, even if the vacuumpump is running.

Are here experienced users of a Rover 13 or likewise machine who can help me out?

Regards

Christiaan

[acetron]

Hi, I too have a rover 13 and I am having some problems but I think we just about have it fixed. The limit switches seem to be rather flakey so we are in the process of cleaning the ones we can and replacing the ones that are really bad. We are getting error 3 on the panel and can only run the machine if we bypass the switches all together. I am in need of a operators manual for the NC 400 for this machine so if anyone has a pdf of it please email it to me. [email protected]

[tecnicocnc]

hello Cristiian

do you resolved your trobules?

do you known Biesseworks

we have finish training and installation for rover 13
if you need something
here i am,

[alfonsonog]

Hello guys, does anyone know what type of servo motors uses the biesse rover 13 s cnc router?

thanks in advance

[wendtmk]

Hello guys, does anyone know what type of servo motors uses the biesse rover 13 s cnc router?

thanks in advance

You need to open your own new topic for this. Your question does not fit with this topic.