I have a chinese 60 watt laser (1200mm tube) The machine was purchased in April 2021 and has had very light usage.
I use the Cohesion3D LaserBoard and lightburn software. I installed an mA Meter. I have my laser power (on machine not software) at 45 and the mA meter never goes over 20ma
Water cooling CW5000
I have have used this no more than 75 hours in total (this is a really small part of my business which I wanted to increase for Christmas)
So very little use
This has been working like a charm, no problems at all until yesterday
It seemed to be missing parts of a fill (always the same parts) and the meter at some points showed no current at all even at 20% which is what its normally run at
I have added a couple of picture for you to look at. Not sure why but the line lasering seems ok but fill is just not working correctly
I really do not know much about electrics so if thats an issue I need to be very careful
I am not sure if this is a tube issue (hopefully not) a power issue or a software issue
The last line on the picture did not complete due to I turned the extraction air on and it stopped the laser
Thanks
Kim