584,805 active members*
5,258 visitors online*
Register for free
Login

Thread: Kmb1

Results 1 to 3 of 3
  1. #1
    Join Date
    Apr 2006
    Posts
    109

    Kmb1

    Anyone Have schematics for the memory boards?? I Have swapped the big ribbon cable 180* and still nothing. I took an eraser to the contacts on the boards to clean them and nothing. I can get it to say load master but it has a funny symbol after master and a small rectangle in the lower right side of crt but it wont load the master.
    One thing the last program that was ran was a very long G-code program and then it was shut down and the buffer was not emptied is that anything??

  2. #2
    Join Date
    Apr 2006
    Posts
    113
    I use these people...they give free phone support
    jim

    http://www.midwestcnc.com/

  3. #3
    Join Date
    Apr 2006
    Posts
    109
    Thanks, I was wondering if anyone else has had this issue?

Similar Threads

  1. KMB1 dnc almost got it
    By mmachining in forum HURCO
    Replies: 8
    Last Post: 10-11-2007, 01:59 AM
  2. Kmb1 Help!!
    By mmachining in forum HURCO
    Replies: 8
    Last Post: 03-20-2007, 10:07 PM
  3. Hurco KMB1 dnc
    By mmachining in forum DNC Problems and Solutions
    Replies: 4
    Last Post: 01-25-2007, 05:06 AM
  4. Hurco kmb1 BTR ???
    By drill in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 0
    Last Post: 01-10-2006, 06:42 PM
  5. Hurco kmb1 help!!!
    By drill in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 1
    Last Post: 01-03-2006, 06:40 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •