Re: Taig 4029 CNC Lathe
I went to their website, and it is confusing. The description of the 3019 cnc ready lathe says -
"Full Blown CNC Lathe with 1/2-20 Leadscrews, ER16 Headstock and DSLS closed loop control system for faster feeds. Includes 1/4 hp spindle motor, 5C spindle, 2 adjustable Tool Posts, chip guard, motors, control box, Digital Index Signal Processor for threading, Emergency off switch, spindle On-Off control module and Mach 3 software"
So does it have a er16 spindle or a 5c spindle?
Also the description of the 3029cr cnc ready describes it with 1/2-20 leadscrews and 1225 ballscrews? Does it have both leadscrews and ballscrews? I think they are just simple mistakes. Otherwise, they look pretty nice. Especially with the 5C headstock, you can do quite a lot with that for $1700, just add some steppers and a copy of mach3 and your in business.. The 5C headstock is $599, not a bad deal either.
I'd like to hear from someone that has one too. Let us know if you get one.
Halfnutz
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)