[Voss_Machine]

Wondering if anybody is running an ATS 3J collet chuck on a Genos L250e? I need to make a draw tube adapter to change it over from my Cadet LNC-8.
I’d really appreciate if some could measure, or has the dimensions for one.

[deadlykitten]

hy voss from time to time i take chucks down, and drawtube, etc, to clean

thus i can easy measure, and have values for 2 lb lathes, but i don't know if those are relevant to you, as you use a coolet chuck

if possible, take down chuck/coller, measure travel in respect to spindle nose, then mount chuck back, check travel with chuck, etc ... then adapt

how may i help you ? kindly

[Voss_Machine]

hy voss from time to time i take chucks down, and drawtube, etc, to clean

thus i can easy measure, and have values for 2 lb lathes, but i don't know if those are relevant to you, as you use a coolet chuck

if possible, take down chuck/coller, measure travel in respect to spindle nose, then mount chuck back, check travel with chuck, etc ... then adapt

how may i help you ? kindly

I can measure the tube when the new machine arrives. I was just hoping that somebody was currently running the Genos L250 and the ATS 3J...and I could copy the draw tube adapter.

Thanks though.

[deadlykitten]

if the new machine is similar to old one, or the allready existing one you get it new, then there is a chance to request techincal drawing sheet of kitagawa preparation, through your okuma dealer, or direct to your kitagawa rep

i did that a few years ago if configuration is standard from a few years allready, then what you need may be available quick, as arhive