Got a new machine in today and it was dead on arrival. Not sure exactly what is wrong with this machine but its got the Centurion 6 control on it and the whole machine seems in very good shape. It used to be used in a community college so it has only seen limited use. Anyway, The screen just pops up blue and says "no video input". So I whipped out the multimeter and did some testing on the Clock Battery on the CPU. It read .230V so that's dead. So I installed a new battery but I also noticed the LEDs for the CPU Backplane aren't all lit up. So I double checked the power supply and I got +5V, -5V, +11.75V, and -11.75V. But when I check the Backplane Volt that leads to the CPU its only +5V that works. All other voltages are dead. So something is stopping the voltage to the CPU? Anyone got any ideas just trying to set this up and its been a bit of a headache. Thanks!