585,951 active members*
3,988 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking > MetalWork Discussion > Tripple start thread in hole tapping problem

Thread: Tripple start thread in hole tapping problem

Results 1 to 2 of 2
  1. 12-03-2021, 02:07 PM #1
    shahid8845
    shahid8845 is offline Registered
    Join Date
    Sep 2017
    Posts
    5

    Tripple start thread in hole tapping problem

    I am not able to do tapping every time tap breaks when i do on daweoo mill while rigid tapping parameter is active on machine Tap parameters are following
    3start Tap pitch 0.181inch Lead=0.543 major diameter is 0.5inch I am using floating holder and depth of tap in z axis is 1.25 inch any help would be higly appreciated
    thanks
    Reply With Quote Reply With Quote
  2. 12-03-2021, 06:58 PM #2
    Jim Dawson's Avatar
    Jim Dawson
    Jim Dawson is offline Community Moderator
    Join Date
    Dec 2013
    Posts
    5717

    Re: Tripple start thread in hole tapping problem

    Is the tap drill correct for the thread and material? Maybe too small?
    Jim Dawson
    Sandy, Oregon, USA
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Milling a hole - start the EM in center of hole
    By mkhushf in forum BobCad-Cam
    Replies: 4
    Last Post: 05-20-2015, 03:27 PM
  2. Shallow hole tapping
    By Tippy1 in forum MetalWork Discussion
    Replies: 4
    Last Post: 03-13-2013, 03:01 PM
  3. Deep hole tapping
    By Bmac991 in forum MetalWork Discussion
    Replies: 7
    Last Post: 02-08-2011, 02:05 PM
  4. Re-tapping a hole VF-7
    By laka in forum Haas Mills
    Replies: 1
    Last Post: 12-06-2010, 11:01 PM
  5. deep hole tapping problem
    By ak_crabber in forum MetalWork Discussion
    Replies: 9
    Last Post: 02-06-2009, 12:44 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules