Hi
I use shielded wiring in my homemade router build, but I´m not sure where to connect the shielding?
On SmoothStepper I use DB25 terminals, they have usual GND pins and one marked GND?
On the Drivers side, do I connect the shielding to the ground wire connection?
On VFD- U,V,W,E. Do I connect the shielding to earth?
And yes I know that shielding needs connection on only one side of the wire.
On cnc metal frame I don´t use any ground connections. Every Nema, Spindle, End switch has its own GND by wire. Is this ok?