[9xpro02]

HI EVERYONE!
I AM NEW MEMBER.
TODAY MY MACHINE WAS HOOKED UP WITH ALARM " NO SUBPROGRAM FILE" BB1: A.MIN, , BB1: . SUB.
I CAN'T FOUND ANY DOCUMENT RELATE FOR SOLVE IT.
SO PLEASE KINDLY HELP ME!
I AM SORRY BECAUSE MY ENGLISH SO BAD.

I AM LOOKING FORWARD TO YOURS ANSWER!


BEST REGARDS.

[Superman]

#1 - STOP yelling... use lower case to talk

The control is trying to find a sub-routine file called A.SUB when you PSELECT a new program called A.MIN

Look at either Programming manual or Operation manual for section on File structure & Sub-Program calling

[9xpro02]

Thank you so much for your help.
Unfortunatetly, my machine was lost all documents relate and Okuma system so fresh with me.
So, please hlep me more details for how to solve it and sent for me somes document that relate with OH-OSP-HMG system if you have.
This is my email address: [email protected]


I am so sorry about inconvenient.

Best regards.

[OkumaWiz]

The machine tries to recall the last program used when it powers up. If that program has been deleted then it cannot find it and in your case it appears that there was a SUB program being used along with the MIN (main) program.

Superman is correct so PSELECT a new program and the problem will probably go away. If not the make sure there is no “O” in the file name because Okuma considers them a SUB as in CALL O1234. ….your code … RTS.

Best regards,

[9xpro02]

Thank you so much for your's reply!
I was tried found the manual of OH-OSP-HMG system but i can't. So please give me more details
And, if you have the document that relate with my machine please sent for me via my email: [email protected].
I so sorry about inconvenient.

Thank and best regards!