I have a Haas VF1 and just loaded a .5" SQEM that had a actual dia. was .5024. All my parts are coming out to small on the OD. I am not sure how I compensate for that over size. If there is a process I need to go through on my offset page or not. Looking for some direction. I have turned cutter comp on in my posted file using G41 but not sure if that is all I need to do.

There are a few lines of the code for this tool



G20 G40 G80 G90 M09
G103 P0
T02 M06
M01
S10000 M03
G43 H02
(msg,watchforair)
M08
M83
G00 G90 X.135 Y-.9827
Z.2631 M08
G01 Z.0731 F30.
G41 Z-.0269 F15. D00
X.1352 Y-.6318
X.1163 F30.
G02 X-.0001 Y-.6177 I.0057 J.5328

Not sure if the D00 is correct or not. I use a probe to set all my tools length and diameter.

Any direction I can get would be greatly appreciated...

Thanks

Steve