Hi. I am making a lathe to use with glass. These require head and tail stock to turn in unison and they are VERY expensive so Im making my own.
Could use advice on my new setup.
I know the wiring is correct and when I turn the dial it whirls faster and slower but doesnt turn the shaft. Here are my specs. Any advice?
NEW SPEED CONTROLLER
Input: DC 7.5-24V
+24V input
+5V output
NEW SWITCHING POWER SUPPLY
24V
5A
NEW CONTROLLER
Output current: 0.5A-4.0A
Input Voltage: 9-42VDC
NEW STEPPER MOTOR WITH LATHE CHUCK
2phase nema23 stepper motor
4.2V
3 A