After leaving for vacation for 3 weeks, my battery died and I lost all parameters. I added the backup battery kit, so that is resolved...but now my mill is a 8000lb brick.

Here is a list of my faults after boot up:

102 SERVOS OFF
201 PARAMETER CRC ERROR
203 LEAD SCREW CRC ERROR
204 OFFSET CRC ERROR
261 ROTARY CRC ERROR
205 PROGRAMS CRC ERROR
250 PROGRAM DATA ERROR
212 PROGRAM INTEGRITY ERROR
149 SPINDLE TURNING
120 LOW AIR PRESSURE
122 CONTROL OVER HEAT
119 OVER VOLTAGE

I have no backup- The dead battery came on without warning while I was gone. There is no spare backup disk in the E-cabinet of this age machine. I called HAAS and they do not have backup files for my S/N. Their only solution was to send out someone for service. I'm still awaiting that quote, but I'm sure it will be expensive and out of my reach.

Is there ANY other way I can get some of these basic parameters???

I'm a brand new startup company and cant really afford a stupid error like this, but if someone can point me in the right direction, I'd be most appreciative. Give me instruction on setting parameters, offsets, etc. Anything.

I've attached a couple shots of my monitor.