Hi, I have an iMach P1A-S pendant running on a Windows 10 64 bit version of UCCNC however the jog wheel only seems to work correctly with each axis traveling in one direction only. So for each axis, the jog wheel moves the axis correctly in say, X+ but running the jog wheel in X- the axis will not move at all or move intermittently. All three axes are the same. I have updated the firmware on the pendant to the correct version for UCCNC and I have enabled the plugin for UCCNC. Prior to using UCCNC I was using Mach3 and Mach Standard Mill with the same issue. Each time I updated the firmware for the pendant but the result was the same.
This problem has been steadily getting worse but when I first purchased the pendant it worked fine.
Could this be a problem with the jog wheel itself? Is there a way of testing the jog wheel to check for pulses in both directions?
Regards,
Mark Presling