Hi all .,
I am about to move my whole setup from a makeshift mdf board to a industrial cabinet.
And since the location of the cabinet is gonna be on the other side of the wall next to my cnc the cables running from my steppers to the drivers would be just short of making nice arrangement of drivers in the cabinet.
I have LOADS of industrial Siemens rail terminal blocks , will there be any problems using the blocks close to where the cables enter my cabinet , and then running from terminal blocks to the drivers ?
These are Nema23 , 3A steppers , industrial drivers from JVL and Ölflex fd classic 810 CY cables...
Im just wondering if there can be any interference when using a terminal block.
All inputs are appriciated