I'm doing a conversion of an Emco F3 mill to CNC and have chosen the Eding CNC720 with an UIO-10 expansion board as the controller. You can follow progress over on the Emco Mills sub forum.
I'm doing a conversion of an Emco F3 mill to CNC and have chosen the Eding CNC720 with an UIO-10 expansion board as the controller. You can follow progress over on the Emco Mills sub forum.
I'm trying to figure out how to wire the driver alarm output from the 3 (x y z) drivers into the DRVALM input.https://www.cnczone.com/forums/stepp...ml#post2491938
Any help would be appreciated. Thanks