584,850 active members*
4,540 visitors online*
Register for free
Login
Results 1 to 2 of 2
  1. #1
    Join Date
    Jan 2022
    Posts
    1

    Heidenhain iTNC 530 Start Up Troubleshooting

    I am new user of the Heidenhain iTNC 530 installed in a Mikron HSM 200(U) LP. Afetr power up and press the CE key I open and close the access door and the following box message appears with a progress bar "Switch on external dc voltage" the red bar run complete and again start from 0 to 100 in a loop that never end. I can not operate or bring the machine to go in a normal run state. I attached some pictures. Not sure If I make a correct start procedure. See pictures attached. Thanks
    Attached Thumbnails Attached Thumbnails pic1.jpg   pic2.jpg  

  2. #2
    Join Date
    Mar 2016
    Posts
    322

    Re: Heidenhain iTNC 530 Start Up Troubleshooting

    There is ON button near e-stop. Push it firmly for 1- 2 seconds until it starts external devices (may also get lighted).

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •