Good day. I have Multicam machine. Some days ago it started to work with problems of remote control device. It happens in the end of work file (but not for every file, just sometimes). In this case I have to power off the machine and wait for 10-15 minutes minimum. After this time I power on the machine and I could continue working until this trouble appears again. If machine stays powered off for a long time (a whole night for example) then it could work 6-7 hours without this trouble appearing. But after this time problem appears with less time period and in the end of day it could happen every 30-40 minutes even when machine cuts the material somewhere in the middle of work program.
My Multicam machine:
Remote control device:
Its normal state:
Some kinds of its troubles:
The control board where this remote control device is connected:
Is there any way to solve this problem??
Thanks in advance.