[TRussey]

I'm retrofitting a DM4400 and will have most all of the hardware from in the control cabinet available as well the X, Y, and Z axis steppers, encoders, and cables for sale. I will list them all on eBay at some point and link in the eBay portion of the forum. Just wanted to extend a general post in case someone is looking for something in particular. Please PM me if you are after parts.

Also this machine was the SKIP controller and would power up but the previous owner couldn't get it to initialize one day. So the some parts may be a gamble.

Tim

[rejeanfortin]

do you still have the stepper motor for it and are they good
i did a retrofit on it but still have them
you can write me at
what kind of stepper motor did you replace them with
[email protected]

[rejeanfortin]

do you still have the stepper motor for it and are they good
i did a retrofit on it but still have them
you can write me at
[email protected]

[TRussey]

Hi,
Sorry for the delay I didn't get post notifications. I do still have the stepper motors. I replaced the stepper motors with DMM servos.
- [DYN4-H01A2-00] - DYN4 AC Servo Drive
- [86N-DHT-A6MD1] - 0.75kW AC Servo Motor

Best,
Tim