Hi Folks,
I have a 1988 QT8-SP Lathe. Up until a couple of months ago it was running fine. Then one day I turned it on to do a job and the home screen came up then went off and it hasn't come back on. I've tried replacing different boards in the control that I sourced from ebay. So somewhat questionable as to if they are good or not. But they don't seem to change anything related to the video. Intermittently there is a change in the video whether it has any input to the monitor or not. Sometimes it gets power but no signal. Other times it may have a black screen with just a cursor in the top left corner. Occasionally it may show ERR 03 in the top left corner and on the bottom it may show 13 drive error. Currently the parameters have been cleared so possibly the 13 drive error is from that. I've checked all of the grounds that I can find. All of the control voltages are correct (5v, 12v, 24v, 100v) The monitor is a 14" LED running on an X-Box converter. I tried a new converter in case that was bad. Haven't found anything that makes any real change that is consistent.
So I'm looking for some help or direction to go that may get this old dog back to humming along again. This is my first post on this forum so I'm really hoping there is someone on here that can help.
Thanks,
Bob