I have a 2011 vintage Hurco VMO running winmax 09.01.312.19 ST. while performing the calibration the machine stopped and rebooted itself. After the reboot process the red message:
NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM. So how do you go about resolving this issue.
Results 1 to 1 of 1
-
10-05-2023, 02:28 AM #1
Registered
- Join Date
- Dec 2005
- Posts
- 29
No motion control boards were detected in the system.
Reply With QuoteSimilar Threads
-
NO MOTION CONTROL BOARDS WERE DETECTED IN THE SYSTEM
By fsebascg in forum HURCOReplies: 2Last Post: 12-12-2020, 07:13 PM -
Looking into motion control/breakout boards and after recommendations
By willheg in forum LinuxCNC (formerly EMC2)Replies: 8Last Post: 10-07-2020, 10:39 AM -
Recommendations on motion control boards & Single Board Computer
By mike944 in forum Controller & Computer SolutionsReplies: 11Last Post: 12-12-2018, 09:57 PM -
BoB & Motion Control Boards ?
By coils in forum CNC Machine Related ElectronicsReplies: 6Last Post: 10-16-2014, 02:23 AM -
DynoMotion K-Flop vs MicroKinetics MN400 Motion Control Boards
By beduion in forum Controller CardsReplies: 3Last Post: 07-27-2010, 08:47 PM
Tags for this Thread
Posting Permissions
