585,919 active members*
4,141 visitors online*
Register for free
Login

Thread: M code help

Results 1 to 4 of 4
  1. 04-20-2022, 04:58 PM #1
    rej
    rej is offline Registered
    Join Date
    May 2010
    Posts
    20

    M code help

    in y post processor i added a line of code, M73, and it starts my vac pump. but then the file stops. is there an extension or a prefax i'm supposed to add as well? tia
    Reply With Quote Reply With Quote
  2. 04-20-2022, 07:01 PM #2
    Jim Dawson's Avatar
    Jim Dawson
    Jim Dawson is offline Community Moderator
    Join Date
    Dec 2013
    Posts
    5717

    Re: M code help

    What machine? Controller?
    Jim Dawson
    Sandy, Oregon, USA
    Reply With Quote Reply With Quote
  3. 04-20-2022, 07:25 PM #3
    rej
    rej is offline Registered
    Join Date
    May 2010
    Posts
    20

    Re: M code help

    atc, syntec controller
    Reply With Quote Reply With Quote
  4. 04-20-2022, 07:55 PM #4
    Jim Dawson's Avatar
    Jim Dawson
    Jim Dawson is offline Community Moderator
    Join Date
    Dec 2013
    Posts
    5717

    Re: M code help

    I can't find any reference to M73 in the syntec manual I could find on line. Do you have a link to your manual?
    Jim Dawson
    Sandy, Oregon, USA
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Need help with g code for fire control pocket on AR15 lower reciver, have G code.
    By DigitalPunk in forum RFQ (Request for Quote)
    Replies: 51
    Last Post: 09-16-2020, 01:28 AM
  2. Can I use G-code/M-code to control external device by Weihong controller?
    By dungvv in forum Controller Cards
    Replies: 3
    Last Post: 02-27-2019, 09:53 PM
  3. Program to Convert Mill g code To Laser g code - CMTL
    By doanwannapickle in forum Visual Mill
    Replies: 0
    Last Post: 02-20-2017, 06:08 PM
  4. mach3 crashing with run of code/drilling holes through table with other code
    By normalform in forum Mach Software (ArtSoft software)
    Replies: 1
    Last Post: 07-28-2014, 03:38 AM
  5. corel.hpgl > sheetcam.tap > pronterface.g-code > slic3r.g.code> ramps 1.4 > H-BOT
    By thesignworks in forum Uncategorised CAM Discussion
    Replies: 0
    Last Post: 05-25-2014, 02:11 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules