My PCV40 was down for a time. Battery went dead. I have recharged it by powering it up and leaving it idle until the battery alarm has cleared. On the screen I see no X Y or Z on the position screen. Also most of the LEDs on the control panel are blinking simultaneously keeping me from selecting modes. I recalled doing a reset of the motherboard. I have that procedure which I will try next. I have the procedure for entering parameters that was faxed to me years ago. I am missing a page of that.
Would any of the elders here have that info? I called Mitsubishi more than once and got nothing.
This is an 86M control. Machine has a build date of 1986.
Thanks,
Mark Neary
Results 1 to 2 of 2
-
05-10-2022, 07:26 PM #1
Member
- Join Date
- Dec 2020
- Posts
- 3
Mitsubishi Meldas 86M on OKK PCV40
-
11-01-2022, 02:41 AM #2
Member
- Join Date
- Sep 2021
- Posts
- 43
Re: Mitsubishi Meldas 86M on OKK PCV40
DEAR SIR.
I AM THUONG FROM VIETNAM.
I HAVE THE OKK MACHINE THAT UNDER THE CONTROLLED BY MELDAS 86GII.
I THINK BOTH THE CONTROLLER ARE THE SAME TYPE.
SO IF YOU HAVE THE MAINTENANCE MANUAL OF MELDAS 86M. PLEASE SHARE WITH ME WITH YOUR GENEROSITY.
THANKS AND BEST REGARDS
Reply With Quote
Posting Permissions
