585,712 active members*
4,411 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Leadshine > ACS806 and ACM604V60-01-1000 tuning

Thread: ACS806 and ACM604V60-01-1000 tuning

Results 1 to 2 of 2
  1. 05-17-2022, 06:50 PM #1
    Mud_
    Mud_ is offline Registered
    Join Date
    Oct 2017
    Posts
    21

    ACS806 and ACM604V60-01-1000 tuning

    Hi, I have the ACS806 (V2) driver and ACM604V60-01-1000 servo motor (well, 4 pairs...), and I'm struggling to get started. The current tuning response dips below the purple line (negative current?), whilst the manual makes it look like it should return to the purple line. Any attempt at motion is violently jerky and trips the over-current. See attached for current trace.

    There are certain configuration values (inductance, inertia, resistance, etc.) the software won't let me set - I'm not sure if that's related. I have set rated current, motor pole pairs, encoder lines and position following limit at least.
    Reply With Quote Reply With Quote
  2. 05-17-2022, 07:23 PM #2
    Mud_
    Mud_ is offline Registered
    Join Date
    Oct 2017
    Posts
    21

    Re: ACS806 and ACM604V60-01-1000 tuning

    Further plot, showing what happens if I try the position loop, even with very low values.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Prolight 3000 lathe & Prolight 1000 mill with “INTERFACE CARD FAILURE ERROR 1000"
    By Prolight3000 in forum Benchtop Machines
    Replies: 1
    Last Post: 03-25-2019, 07:21 PM
  2. Position following error on ACS806 + 57BL180D-1000 servo kit
    By Moriduri in forum Leadshine
    Replies: 1
    Last Post: 07-23-2017, 08:47 PM
  3. Problem with driver ACS806
    By thachdovan in forum Leadshine
    Replies: 0
    Last Post: 12-26-2016, 06:06 AM
  4. Haas HPC-1000/TSC-1000 coolant pump, like new!
    By stuntjake912 in forum For Sale Only
    Replies: 0
    Last Post: 03-14-2016, 03:05 PM
  5. Leadshine ACS806 AC servo ...smoked !
    By Larken in forum Leadshine
    Replies: 0
    Last Post: 08-15-2014, 03:31 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules