[Phil_Par]

I came across a few different PD settings and generally understand the majority of them, but have a question on a few that are different from what the manual recommends

Recommended in forum
PD007 - 20
PD009 - 15
PD010 - 8
PD041 - 8

Recommended in manual for this particular model
PD007 - nothing
PD009 - 13
PD010 - 6.5
PD041 - 8

Which values should I use?

Thanks!

[mactec54]

I came across a few different PD settings and generally understand the majority of them, but have a question on a few that are different from what the manual recommends

Recommended in forum
PD007 - 20
PD009 - 15
PD010 - 8
PD041 - 8

Recommended in manual for this particular model
PD007 - nothing
PD009 - 13
PD010 - 6.5
PD041 - 8

Which values should I use?

Thanks!

It depends what motor you are running as to what those Parameters are set at the Default in the VFD Drives are either for a 50Hz or 60hz motor the Parameters you found are most likely what I have posted and are for 400Hz high speed spindle motors

So, depending on the motor you are using will depend on the VFD Drive Parameters to be set.

[Phil_Par]

It depends what motor you are running as to what those Parameters are set at the Default in the VFD Drives are either for a 50Hz or 60hz motor the Parameters you found are most likely what I have posted and are for 400Hz high speed spindle motors

So, depending on the motor you are using will depend on the VFD Drive Parameters to be set.

It is for a 400Hz spindle 220v - 2.2W water cooled. So the parameters would be?
PD007 - 20
PD009 - 15
PD010 - 8
PD041 - 8

Thanks!

[mactec54]

It is for a 400Hz spindle 220v - 2.2W water cooled. So the parameters would be?
PD007 - 20
PD009 - 15
PD010 - 8
PD041 - 8

Thanks!

If
PD007=20
then
PD010=11