Originally Posted by
Prairiehawk
Hi All
I bought a Mastercam Z7 with the A2MC upgrade. A bit of an issue getting the router to operate. The computer initializes and the spindle will start/warm up, but the gantry and carriage will not move, either manually or in a job. I get an error message (E103) when I do a function F12. The sensors all work when tested, all fuses are ok. Power is getting to the power distribution board that feeds the servo controllers in the control box. The servo controllers all have a red light that periodically flashes on them. Does anyone know what I could check to see what the issue may be?
Any insight would be much appreciated.
Thanks