I was wondering how the Error Input on the Axis connector is working.
As there is no Invert option, I asume that a failure should connect the Error input to GND or 5V??
But how to connect a drive which sends a OK signal which is on, when there is no failure?
Results 1 to 1 of 1
Threaded View
-
06-21-2022, 08:50 AM #1
- Join Date
- Jan 2022
- Posts
- 107
Questions about the Error Input of the Axis connector
Reply With QuoteSimilar Threads
-
Difference I/O signals via ExtIn board or INPUT OUTOUT connector
By hoizlaender in forum PlanetCNCReplies: 2Last Post: 07-26-2021, 09:03 PM -
OP connector sanyo denki servo PV drive - looking for connector
By gm276 in forum Want To Buy...Need help!Replies: 2Last Post: 12-15-2018, 07:39 PM -
Thanx for the input , few more questions
By mikeblais24 in forum BobCad-CamReplies: 0Last Post: 01-23-2009, 03:29 PM -
Motor wiring/connector questions
By dfro in forum Stepper Motors / DrivesReplies: 2Last Post: 10-13-2008, 09:07 AM -
Newbie questions, would appreciate any input
By neighborator in forum MoldmakingReplies: 1Last Post: 01-27-2008, 01:10 AM
Tags for this Thread
Posting Permissions
