Hi all,
80W chinese laser with Ruida controller, Lightburn software. Has been working well up until today, no changes have been made (that I'm aware of-the machine is still new, is it possible to accidently reset factory settings?) Now the machine randomly makes a knocking noise, and I get missed steps resulting in broken lines, or straight lines become misaligned as the laser skips appx 0.5mm to the side. FYI I am cutting at 100mm/sec.
Strangely, it only does this when the laser is active, if i turn the laser off, and run the same code, there is no issue.
What could be going on here? Any assistance much appreciated