585,992 active members*
5,159 visitors online*
Register for free
Login

Thread: rotary help

Results 1 to 2 of 2
  1. 09-10-2007, 09:53 PM #1
    dpark1
    dpark1 is offline Registered
    Join Date
    Aug 2007
    Posts
    95

    rotary help

    I have attached my program with toolpath to run on fadal with 4th axis,just wanting someone to check my toolpath out, because I have very little rotary experience. Thanks


    p.s. version 9.1
    Attached Files Attached Files
    Reply With Quote Reply With Quote
  2. 09-11-2007, 01:35 AM #2
    crazythunder
    crazythunder is offline Registered
    Join Date
    Sep 2007
    Posts
    217

    What did it look like on the machine??

    I would set my Z offset about 4 inches above the part and run and see what you get. Get some scrap material and cut the part. Experience is the best teacher hands down.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Rotary Milling
    By binzer in forum GibbsCAM
    Replies: 3
    Last Post: 12-07-2007, 04:56 AM
  2. Rotary table
    By Piobaire in forum HURCO
    Replies: 0
    Last Post: 08-22-2007, 01:30 PM
  3. help with rotary
    By quemast in forum GibbsCAM
    Replies: 1
    Last Post: 05-27-2007, 06:16 PM
  4. 4 Axis Rotary
    By Smackre in forum Mastercam
    Replies: 3
    Last Post: 08-09-2006, 05:28 PM
  5. Useful for Rotary Table?
    By Ken Stuempge in forum Mechanical Calculations/Engineering Design
    Replies: 2
    Last Post: 02-12-2006, 04:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules