Hello, I'm new to Haas. Our previous mill had a Z lock function that allowed us to lock the Z movement while cycling through the program. This was very beneficial as we mainly drill hundreds of holes into plates. Currently, we are using a canned cycle to do the drilling. However, if we run into an issue, we have to start the program from the beginning. On the previous machine, we would lock the Z motion and rapid run through the program until we are at the next desired hole. Is there a way to lock the Z and run rapid through the canned cycle on a Haas? Since it is a canned cycle, if we start from a line it starts at the beginning of the rows. If Z lock is not an option, does anyone know the best way to start in the middle of a canned cycle?