Hello..
My Adira Press Brake PMO 13530 with adcontroll 10.
The machine can't indexing/home position. This is used machine and new for us.
any advice or manual book will be very appriciated.
Regards,
Komang.
Hello..
My Adira Press Brake PMO 13530 with adcontroll 10.
The machine can't indexing/home position. This is used machine and new for us.
any advice or manual book will be very appriciated.
Regards,
Komang.
Hello again..
Today I checked the machine and tried move the axis using diagnose mode. For Y axis and X axis working good, only R axis alarm AX1152 Axis R1 forward LS sometimes backward LS depends where you move the axis. I tried disconnect LS cable to servo amplifier but the problem still same.
Last I disable R axis on the parameter, and the machine can indexing/home position. But when we use the machine for production, for the closing the speed is very low. I have adjust speed on the axis parameter (fast descent parameter and work descent parameter) but nothing change.
I remember previously on Amada HFT we have same problem because there are jump cable/brige on the robot connection. I don't know it's same problem or not and I need help to figure it out.
Any help will be very appriciated.
Regards,
Komang