[Vlod]

Here is a good example
https://www.airspayce.com/mikem/ardu...e-example.html

[The Druid]

Vlod, it worked great right off the bat thanks!

I am trying to achive as follows;

I have a ballscrew and would like it to go clockwise until it hits a limit switch then reverses direction; anticlockwise, again , hits another limit switch, then reverses direction back and forth and goes all day long.


Is this possible? with TB6600, Adruino.

I hope so.

I hope this isn’t too late to help.
An Arduino isn’t required for your task.
I have a length of ball screw in a frame, with a stepper motor and its driver, complete with two end switches and a control box wired as this example.
It functions just as you require, an endless to and fro from one end limit to the other with the speed set by the knob.
I use it to test stepper motors and their drivers in an endless soak test.

Attachment 486110
Attachment 486112
Attachment 486114
Attachment 486116