Another question:
With new OptoIso limit and input adapter I've all to 24VDC (including MK3 main board, adapter ecc.) except Output board for spindle control, is correct?
It's not possible solve this discrepancy?
Another question:
With new OptoIso limit and input adapter I've all to 24VDC (including MK3 main board, adapter ecc.) except Output board for spindle control, is correct?
It's not possible solve this discrepancy?
I suggest you use 12V for everything if possible. It is more efficient than 24V.
Ah, ok, so I need two separate PSU.
I was hoping one would be enough, for to simplify my work
Thank's
C.
It is recommended that controller uses its own power supply.
ok, thank's again