Hello all,
I am looking for any info on the code specific to the MXP 200i fanuc tap cycle. Dropping the inquiry here while I search online and in online manuals. Of course, our shop lost the manual. Thank for any help!!!
Hello all,
I am looking for any info on the code specific to the MXP 200i fanuc tap cycle. Dropping the inquiry here while I search online and in online manuals. Of course, our shop lost the manual. Thank for any help!!!
Hi,
I assume you have a YCM, on my MXP-100i it is something like:
Alert >>>> Metric example for rigid tapping with a M10 x 1.5 metric tap !!!!!!
....
G95 ( MM/REV )
M29 S300
G84 Z-20. R3. F1.5
G80
G94 ( BACK TO MM/MIN )
....
- or
....
G94( MM/MIN )
M29 S300
G84 Z-20. R3. F450. ( F=300X1.5 )
G80
....
- or G120 P1 cycle for Bolt Hole Circle Pattern for Drilling (G73-G81) or Tapping (G84):
....
G94( MM/MIN)
M29 S300
G84 Z-20. R3. F450. K0 ( F=300X1.5 )
G120 P1 X0. Y0. D100. A0. K6
G80
....
( P1 = BOLT HOLE CIRCLE )
( X,Y = CIRCLE CENTRE )
( D = CIRCLE DIAMETER )
( A = FIRST ANGLE )
( K = NUMBER OF HOLES )