I have a Fadal 15 XT. Today we had an overtravel hardstop in the Y. The machine will jog on all axis but when a command control is sent we immediately get a "Failure setting servo gain" fault. ??? Is this an issue with the controller card? Can I swap controller cards from different fadals.
Thread: Failure setting servo gain
Results 1 to 2 of 2
Hybrid View
-
10-27-2022, 03:13 PM #1
Member
- Join Date
- Oct 2022
- Posts
- 1
Failure setting servo gain
-
11-16-2022, 06:19 PM #2
Member
- Join Date
- Feb 2014
- Posts
- 227
Re: Failure setting servo gain
I would start by reading this and check.
https://flintmachine.com/images/uplo...ve_Systems.pdf
may have bad gain pot on board or drive or loose wire.
Be very careful with the trim pots and easy to break off, I did just that. I used to big of screw driver to adjust mine and had to solder it back on the drive.
Reply With Quote
Posting Permissions
