[joelbonato]

I’m a proud owner of the Cnc4newbie hsnc4848rp
and I was needing some assistance, first off I’m almost done with my assembly and I am in the process of wiring. I have a huanyang VDF and spindle. I’ll suppy pictures. I was wondering how to wire the vfd to the controller. Also if you have any program info for the vfd that is compatible with uccnc.


Sent from my iPhone using Tapatalk

[mactec54]

I’m a proud owner of the Cnc4newbie hsnc4848rp
and I was needing some assistance, first off I’m almost done with my assembly and I am in the process of wiring. I have a huanyang VDF and spindle. I’ll suppy pictures. I was wondering how to wire the vfd to the controller. Also if you have any program info for the vfd that is compatible with uccnc.


Sent from my iPhone using Tapatalk

It is quite straight forward you need a PWM to Analog 0-10v to control the spindle speed and a Relay to Turn it 0n /0ff, so check to see what you Hardware has

The main Power wiring to the VFD Drive will connect to R / T Terminals Plus Ground/ Earth to the PE Terminal

What are is the spindle motor specs???