Whats up people
I got my self 2 old emcos from a education use.
Its a emcoturn 120 emcotronic t1
And a Concept mill 55 with siemens 810 simulation
Problems are
I cant get the EmcoWinNc connect with machine.
Lighta on the network card flashes and the greenred bar on the program moves but it wont connect.
Where to start searching?
The lathe then
I have no idea how to use this control
It starts but has alarm 13 and 46. Input value out of range and Reference not found.
I enter the reference meny but i cant get any axis active
On diaplay EMERGENCY OFF is on alltime.??!
I have no manual for this control
Anyonr have a copy?
Best regards
Anttoni