Hello all,
I face a really strange tolpath behaviour with camworks.

In camworks simulation, toolpath OK.
In c!amworks virtual machine, toolpath OK when it mills.
In camworks virtual machine, toolpath NOK when entry / retract trajectory. It seems that the GCODE creating for entry / retract toolpath is not the good one, like it add an offset or take the wrong coordinate systems, something like that.

So the question is : How is it possible that the gcode generated is OK for normal toolpath but NOK for entry/retract toolpath ?? (Knowing that in the simulaton camworks, everything works fine)

I put some pictures to illustrate the issue.

Thanks