I have OSP700L, OSP7000L, OSP U10L and OSP U100L. A new job I'm putting in does not use the draw bar for clamping. The fixture has strap clamps to hold the part. I'm looking for a way to orient the spindle and lock it in place for load. The M19 does not work on them for orientation. I think I could use a threading cycle at the end of the program to get the orientation. But I still need a way to lock it to tighten the clamps. I could use any of the above machines to run it. So it it possible on any of them? If so how?


Edit:
None of these machines have live tooling.